Raimondi RLS – H.D. Clips 2200 st. 1,5mm 3-12mm Leveling Spacers
$205.00 INC VAT
Raimondi RLS levelling system clips (1.5mm) with base for use with the Raimondi Levelling System and suitable for tiles of thickness 3mm – 12mm. The joint gap is 1.5mm. Choose various pack sizes, the bigger the pack, the better the value
How to use
After spreading your tile adhesive, first, insert a levelling spacer underneath the tiles along the 4 sides. Next, use traditional spacers as you normally would to square up the corners. For larger tiles, you may have to “double-up”, using two levelling spacers for each side.
Set the tile and beat it with a rubber mallet.
Use special traction-adjustable pliers to insert the wedge into the levelling spacers. You should pay attention not to pass the breakpoint.
After waiting for the tile adhesive to set, you should remove the levelling spacers. You can use either the traction-adjustable pliers, a rubber mallet, or by kicking them out with your feet.
How to insert the wedge
- Insert the wedge in the support slot, taking care not to pass the breaking point.
- To facilitate this operation, we recommend using the special traction-adjustable-pliers.
How to remove the support
Finally, once the adhesive is set, you should remove the protruding part of the support by separating it from the base. You can do this by using the traction-adjustable-pliers, with a rubber mallet or even with feet. Then beat the spacer until it is parallel to the joint.